Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Seeking a 4-8 port 10 GbE RJ45 switch with stp+ uplink, no PoE?

#1
Seek to connect my QNAP TS-870 with dual port 10 GBE RJ45 to my 2 PCs running Intel 10 GbE RJ45 NICS. my previous Netgear 10 GbE switch was water damaged and need a replacement.

Any suggestions?

No PoE required but sfp+ required for uplink connectivity to my Unifi UDM Pro. small setup no need for anything over 4 to 8 10 GbE RJ45 ports
Reply
#2
(11-18-2020, 05:47 PM)gatox Wrote: Seek to connect my QNAP TS-870 with dual port 10 GBE RJ45 to my 2 PCs running Intel 10 GbE RJ45 NICS. my previous Netgear 10 GbE switch was water damaged and need a replacement.

Any suggestions?

No PoE required but sfp+ required for uplink connectivity to my Unifi UDM Pro. small setup no need for anything over 4 to 8 10 GbE RJ45 ports
Microtik CRS310-8G+2S+IN  great hardware just bought one  for under $200. However it has a learning cure to configure especially if you are not familiar with networking. It's actually a router but by design  can be put into bridge mode to act as a fast layer 2 switch. 




CRS310-8G+2S+IN and it turns out you CRS310-8G+2S+IN and it turns out you and it turns out you
Reply
#3
For your setup, I'd recommend checking out the Netgear XS708T or the TP-Link T1700G-28TQ. They both have 10 GbE RJ45 ports and SFP+ for uplink to your Unifi UDM Pro.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)