01-10-2024, 05:30 PM
I have just purchased a new DS1522+ and prior to permanently setting it up was running through various tutorials. I removed a drive tray and drive to simulate a drive failure intending to check the process through. This is when things went wrong.
Having removed the drive from the tray I pushed the tray back in but had not refitted the drive securing strips, the drive tray went too far in and it now firmly stuck. I can now see drive securing strips hit a couple of raised lugs in the back of the DS to stop this happening.
Has anyone else been this daft and sorted it out. I guess I can probably cut through the tray and release it but that is far from my plan.
Any good ideas welcomed, I don't need beating up about this, I have already beat myself up enough.
Thanks
Steve
Having removed the drive from the tray I pushed the tray back in but had not refitted the drive securing strips, the drive tray went too far in and it now firmly stuck. I can now see drive securing strips hit a couple of raised lugs in the back of the DS to stop this happening.
Has anyone else been this daft and sorted it out. I guess I can probably cut through the tray and release it but that is far from my plan.
Any good ideas welcomed, I don't need beating up about this, I have already beat myself up enough.
Thanks
Steve
