Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Memory upgrade on Synology DS1817?

#2
Officially DS1817 can be upgraded up to 8GB. You can get RAM from SPAN if you search for SynologyDDR3 RAM4GBRAM1600DDR3-4GB4GB SODIMM Memory Unofficially you can upgrade up to 16GB16GB (2x8GB) Kit RAM memory for Synology DiskStation DS1817 DDR3 SO DIMM 1600MHzUK- https://amzn.to/2VBCu0GUSA- https://amzn.to/2whQAd0CA - https://amzn.to/2TaS3e2Add a RAM Module on DiskStationThe optional Synology DDR3 RAM module is designed for DiskStation memory expansion. Follow the stepsbelow to install, check, or remove a RAM module on your DiskStation.To install the RAM module:1 Shut down your DiskStation. Disconnect all cables connected to your DiskStation to prevent any possibledamages.2 Remove the 6 screws that secure the top case. Lift off the case and place it to the side.3 Insert the new memory module in the slot:a Align the notch on the gold edge of the module with the notch in the lower memory slot.b Tilt the card and push the memory into the slot. Make sure the module is pushed in all the way.c Use two fingers with firm, even pressure to push down on the memory module. You should hear a click whenthe memory is inserted correctly.4 Replace the top case. Replace and tighten the 6 screws you removed in step 2.5 Reconnect the cables you removed in step 1, and then press and hold the power button to turn on yourDiskStation.To make sure DiskStation recognizes the new memory capacity:1 Install DiskStation Manager (DSM). (See the next chapter for more information.)2 Log in to DSM as admin or a user belonging to the administrators group.3 Check Total Physical Memory in Control Panel > Info Center.If your DiskStation does not recognize the memory or does not start up successfully, confirm that the memory isinstalled correctly.To remove the RAM Module:1 Follow step 1 and 2 of the "To install the RAM module" section to shut down your DiskStation, disconnect thecables, and then remove the top case.2 Push the levers on the sides of the memory module in an outward direction to release the module from thememory card slot.3 Hold the memory module by its notches and remove it from the slot.4 Replace the top case. Replace and tighten the screws you removed in step 2.5 Reconnect the cables you removed in step 1, and then press and hold the power button to turn on yourDiskStation.
Reply


Messages In This Thread
Memory upgrade on Synology DS1817? - by admin - 03-01-2020, 09:46 AM
Memory upgrade on Synology DS1817? - by pplante19 - 03-11-2020, 12:30 PM
Memory upgrade on Synology DS1817? - by pplante19 - 03-12-2020, 03:57 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)