Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

First NAS

#2
No worries, building your first NAS can be tricky! While I can't vouch for the specific wording of the guide you followed, it's possible UNRAID doesn't see the drives because they need formatting. However, there's a key step before formatting with UNRAID:

Pre-clearing the Drives:

UNRAID recommends a process called pre-clearing to identify any bad sectors on your new drives before adding them to the array. This helps ensure data integrity in the long run.

Here's what you can do:

Don't format the drives yet! Formatting them outside of UNRAID might cause issues.
In UNRAID's interface, look for a section on adding disks or managing storage. It might be called "Main" or "Array Operations" depending on your version.
Locate your new drives and choose the option to "Pre-clear" them. This process can take several hours per drive.
Once pre-clearing finishes, you should be able to format the drives within UNRAID itself. This formatting process is usually much quicker.
Additional Resources:

UNRAID Pre-clearing Guide: https://forums.unraid.net/topic/120567-u...the-array/
UNRAID Forums: https://forums.unraid.net/forum/93-unraid-connect/ (Great community resource for troubleshooting)
Reply


Messages In This Thread
First NAS - by ENQUIRIES - 03-03-2024, 05:00 AM
RE: First NAS - by ed - 03-06-2024, 08:49 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)