Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Netgear GS748TS LAG setup

#1
Perhaps I'm obtuse or just don't understand Netgear's logic?
 
I'm trying, unsuccessfully, to set up a LAG for ports 47 and 48,  in order  to connect to a Bond created on my  DS18211+
 
The steps outlined in this Netgear KB article "How do I set up a LAG between a Smart Managed Pro Switch and a Synology NAS?" don't align with the GS748TS (even though they are in the GS748TS section):
 
This Netgear KB article "What are link aggregation and LACP and how can I use them in my network?" is very general and indeed refers me to the support section (even though that's where I already am):
 
The "GS700TS Smart Switch Software Administration Manual" has a section on LAGs in Chapter 4, but just details settings, not a step by step "how" to set them up.

I've watched SpaceRex's "Link Aggregation on Synology NAS + NetGear - Get Better Performance out of Your NAS! | 4K TUTORIAL"   and whilst I understand the concepts, the GS748TS's web interface is very different.
 
Can someone refer me to a "Netgear Idiot's Guide" or relevant GS748TS  YouTube post?
 
Regards,
Reply


Messages In This Thread
Netgear GS748TS LAG setup - by Gibsonm - 02-24-2023, 02:56 AM
RE: Netgear GS748TS LAG setup - by Gibsonm - 03-01-2023, 02:39 AM
RE: Netgear GS748TS LAG setup - by Gibsonm - 03-02-2023, 10:09 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)