ASK NC
Tvs874 upgrading storage - Printable Version

+- ASK NC (https://ask.nascompares.com)
+-- Forum: Q&A (https://ask.nascompares.com/forumdisplay.php?fid=1)
+--- Forum: Before you buy Q&A (https://ask.nascompares.com/forumdisplay.php?fid=2)
+--- Thread: Tvs874 upgrading storage (/showthread.php?tid=10601)



Tvs874 upgrading storage - Enquiries - 03-22-2024

Can I swap out my 8 12tb drives for 18 TB drives by replacing them one at a time until all 8 bays are populated with the larger drives? I'm running the qts with zfs in a configuration that gives 2 drive loss.. raid 6 I believe.


RE: Tvs874 upgrading storage - ed - 03-22-2024

Yes, you can swap out your 8 x 12TB drives for 18TB drives one at a time on your TVS-874 QNAP NAS with QTS and ZFS configured in RAID 6. This is a safe way to expand your storage capacity.

Here's a breakdown:

Safe method: Replacing drives one by one allows your RAID 6 to rebuild parity information with each drive swap. This ensures data protection even if a drive fails during the process.
ZFS won't expand automatically: While your RAID pool is protected during the swap, the total usable storage won't automatically increase until all the drives are replaced.
Here are the steps involved:

Back up critical data: It's always a good practice to have a separate backup of your important data before any maintenance procedures.
Power down the NAS: Ensure your NAS is properly shut down before swapping any drives.
Replace the first drive: Replace one of the 12TB drives with an 18TB drive.
Power on the NAS: Boot up your NAS.
Storage Pool Management: Log in to your QNAP QTS and go to Storage & Snapshots > Storage/Snapshots.
Monitor Rebuild: You should see a notification about the RAID volume rebuilding with the new drive. This process might take several hours depending on the drive size and system performance.
Repeat for remaining drives: Once the rebuild is complete, you can power down the NAS again and swap the next 12TB drive with an 18TB drive. Repeat steps 3-6 for each remaining drive.


I would recommend backing everything up and starting from scratch. Otherwise, it might take weeks to complete.